1 - 16 Bar Pressure Automatic Self Cleaning Filter Brush Type For Waste Water

1 - 16 Bar Pressure Automatic Self Cleaning Filter Brush Type For Waste Water

Automatic Self Cleaning Filter Introduction

When the water flow gets through the filter, the impurity in the water is held by the strainer With the increase of the impurity accumulated on the surface of the strainer, the pressure difference reaches 0.04Mpa. The switch of the pressure difference will give out a signal while the PLC sends an instruction to start the drive motor and open the drainage valve; the impurity accumulated on the strainer will be brushed off with the rotating brush and discharged from the drainage exit. The whole process of brushing and draining require no personal operation and without machine halt. At the same time, the equipment is with the function of regular washing and draining and manual washing and draining to make sure that the water output is safe and reliable in any case.

Automatic Self Cleaning Filter Technical parameters

■A single maximum flow capacity is up to 4000m3 / h
■Wide filtration range:screens from 4000 to 20 microns
■Working pressure(min)≥0.18Mpa
■Working pressure(max)≤1.6MPa(customized is available)
■Working temperature ≤65℃
■Power supply: 380 v / 50 Hz (Customized is availabel)
■Cleaning method: brush type
■Adjustable cleaning time: 10-200 seconds

Automatic Self Cleaning Filter material
■Brush holder: 304 stainless steel, 316L stainless steel
■Drain valve, cast iron,copper,stainless steel,PVC,nylon
■Controller: PVC, aluminum
■Seal ring: EPDM rubber
■Cleaning brush: stainless steel, nylon

Automatic Self Cleaning Filter structure

Automatic Self Cleaning Filter specification table